Factory Location Oil Pressure Adapter M16x2.0

Product Info

This is a special M16x2.0 fitting allowing an aftermarket gauge or pressure adapter to be added on an Atlas engine in place of the factory oil pressure "sensor". Again, This REPLACES the OE oil pressure sensor/switch location, it will not work in a factory vehicle setup. This is intended for Atlas engine swaps into other chassis that don't use the factory Trailblazer/Colorado "fake reading" gauges.

This is a very hard to find thread size, and a higher quality part than anything you will get on amazon, and you're supporting me instead of Mr. Bezos. This is made out of US Stainless steel and machined by us in Metro Detroit! 

Works with any Atlas engine: 4, 5 or 6 cylinder. The M16x2.0 thread is the exact size as the OEM thread, and the internal thread is common 1/8" NPT or 1/4" NPT to fit a wide variety of sensors, hoses or gauge adapters. Includes new crush washer gasket (not shown in pictures.)

Please note: This fitting will NOT fit the oil galley ports on the side of the block or the un-used port at the front of the oil filter housing. Do not attempt to use it there for oil feeding.